GREIMIN AW-0 is a relatively universally applicable defoamer mainly for defoaming of waste waters.
| Form of delivery: | liquid, possibly with solid parts | |
| Appearance: | yellow – brown, clear – turbid | |
| Density (20 °C): | ca. 0,9 g/cm³ | DIN 51757 |
| Viscosity (40 °C): | 30 – 100 mPa•s | DIN 51562, 53019 |
| pH-value (10%ig): | 4 – 6 | DIN 53996 |
Combination of fat derivatives and higher alcohols
The product can form a turbidity or sediment at longer storage, in particular with lower temperatures. This however does influence neither the effectiveness nor the dosing-ability. GREIMIN AW-0 is not frost-sensitive. The product can be brought into the original state at any time by stirring, pumping or slight warming.
GREIMIN AW-0 is storable in closed delivered packagings under normal temperature conditions (from +5°C to +30°C) at least a year.
GREIMIN AW-0 is only little emulsifiable and should be applied in the delivered form therefore.
Usually the product is used in a concentration of 0.01 to 0.05%. Suitability and dosage are to be determined through own practice tests on site in each case.
In order to reach a good distribution and small proportioning-amounts, it is recommended to add GREIMIN AW-0 at a place where the liquid is turbulent.
Please do not add the assessed amount of the defoamer at the same time. Fundamentally wait a certain time after addition of a small quantity until a good distribution with the watery liquid occurred. Judge the achieved effect only then and add a further amount if necessary.
All information of this publication is based on our present knowledge and experience. It does not free the user of our products from own examinations and experiments. A legally obligatory assertion of specific qualities or the suitability for a concrete operation purpose can not be derived from our information. Possible industrial property rights as well as existing laws and definitions are to be considered by the receiver of our products in own responsibility.